What are the common software problems and solutions for motor motor rotor automatic six-station double flying fork winding machine?
Motor motor rotor automatic six-station double flying fork winding machine common software problems and solutions are as follows:
1、Error in setting program parameters
Problems: winding to hook angle is too large, resulting in the line is pulled into the wire mold, the line is clamped when the mold is closed; winding speed, acceleration is too fast, indexing, hook line speed is too fast, and the speed of the speed with the coordination is not coordinated, affecting the quality and efficiency of the winding, and may even lead to breakage of the line, wire and other issues.
Solution: Check carefully and reset the correct parameters according to the actual production requirements, such as winding angle, speed, acceleration, etc., after the completion of the setup needs to be tested and fine-tuned several times to ensure that the cooperation between the parameters to achieve an excellent state.
2、Software compatibility problems
Problem performance: there is a compatibility conflict between the control software of the winding machine and the operating system, other related software or hardware equipment, resulting in the software can not run normally, error prompts or part of the function is invalid.
Solution: Check the system requirements of the software to ensure that the operating system and other related software versions used by the winding machine are compatible with the control software. If necessary, upgrade the operating system or other software, or contact the manufacturer of the winding machine to obtain a software version compatible with the existing system.
3、Software failure or error
Problem performance: software in the process of running dead, lagging, no response phenomenon, or prompted by a variety of error codes, resulting in the winding machine can not work normally or work abnormally.
Solution: First of all, try to restart the coil winding machine and related control equipment to clear out the possible temporary errors. If the problem still exists, you can check the log file of the software to find the specific description of the error message, and according to the error prompts to carry out the corresponding processing, such as repairing damaged files, updating the driver and so on. If there is a serious software failure, you may need to reinstall or upgrade the control software.
4, data transmission errors
Problem performance: In the process of data transmission, such as from the programming device to the winding machine to transmit winding program, parameter settings and other data, data loss, error or transmission interruption, resulting in inaccurate or incomplete instructions received by the winding machine, affecting the winding operation.
Solution: Check whether the connection of the data transmission line is stable, if it is loose or damaged, it should be repaired or replaced in time. At the same time, make sure that the baud rate, check digit and other parameters of data transmission are set correctly, and avoid external interference, such as electromagnetic interference, during transmission. If you use wireless transmission, you also need to check the signal strength and stability, if necessary, adjust the location of the wireless device or increase the signal enhancement equipment.
5、Software upgrade failure
Problem performance: When upgrading the control software of the winding machine, there are problems such as interruption of upgrade, inability to install the new version or inability to start the software normally after the upgrade, resulting in the winding machine not being able to enjoy the new features and performance optimization brought about by the software upgrade.
Solution: Before upgrading, make sure the equipment meets the hardware requirements for software upgrading, and backup the important production data and setting parameters. During the upgrade process, strictly follow the upgrade guide provided by the manufacturer to avoid power failure or misoperation in the middle of the process. If the upgrade fails, try to re-download the upgrade package and perform the upgrade operation again. If the problem still cannot be solved, contact the technical support staff of the coil winder manufacturer for assistance.
※ If you still can't solve the problem by the above ways and means, please contact the technical specialist of Xinhui Electromechanical Equipment Ltd. through the page chat tool for help.
