How to maintain the brushless motor motor automatic load tester?
Brushless motor motor automatic load tester maintenance is crucial, can be from the hardware and software in two aspects, the following is the specific maintenance methods:
1、Hardware maintenance
l Appearance cleaning: regularly use a clean and soft damp cloth to wipe the shell of the tester to remove dust, oil and stains on the surface. For stubborn stains, you can use a mild detergent, but to avoid liquid into the interior of the tester. Pay special attention to cleaning the vents of the tester to prevent dust from accumulating and affecting heat dissipation.
l Sensor Maintenance: Check whether the connection of the sensor is firm, there is no loose, oxidized or corroded phenomenon, if any, you need to clean or replace the connector in time. Regular calibration of the sensor to ensure the accuracy of its measurement. Standard calibration equipment can be used in accordance with the sensor calibration procedures. For some sensors that are susceptible to wear and tear, such as displacement sensors, etc., check the wear and tear of their mechanical parts and replace them if necessary.
l Maintenance of motor and transmission parts: Check whether the motor is running smoothly and there is no abnormal noise or vibration. Regularly add appropriate amount of lubricant to the bearing of the motor to reduce friction and wear. For the belt, chain and other transmission parts in the tester, check whether its tightness is appropriate, if loose need to be adjusted in time. At the same time, check whether the transmission parts are worn, cracked and other damage, if any, should be replaced in time.
l Electrical system check: Regularly check the tester's power cord, plug, socket, etc. whether there is damage, aging phenomenon, if there is a hidden danger to be replaced in a timely manner. Check the circuit boards, relays, contactors and other electrical components in the electrical control cabinet to see if there are loose, burnt, short-circuit and other problems. Clean the dust inside the electrical control cabinet to maintain good heat dissipation and insulation.
l Mechanical structure inspection: Check whether the mechanical structure of the tester is firm, whether there is any looseness, deformation or cracks and other problems. Check the fixture, working table and other parts of the tester to ensure their precision and stability. If the fixture is found to be worn or deformed, it will affect the accuracy of the test results and should be repaired or replaced in time.
2, software maintenance
l Software update: Pay attention to the official website of the tester software developer or notification channels to get the updated information of the software in time, and carry out the software upgrade operation according to the instructions in order to repair the software loopholes, improve the performance and add new functions.
l Data Backup: Regularly back up the test data, you can set the automatic backup function to back up the data to external storage devices or network servers. At the same time, regularly check the integrity and recoverability of the backup data to ensure that the data can be recovered in time when needed.
l System Optimization: Regularly clean up junk files, temporary files, etc. in the computer system to free up disk space and improve system operation speed. Close unnecessary background programs to avoid seizing system resources with the tester software. Defragment the computer's hard disk to improve data reading and writing speed.
l Anti-virus and anti-malware: Install reliable anti-virus software and firewalls, and regularly update virus databases and protection rules. Avoid installing software of unknown origin on the computer used by the tester to prevent the invasion of viruses and malware, which may affect the normal operation of the software of the tester.
If you still can't solve the problem by the above ways and means, please contact Xinhui electromechanical technical specialists through the page chat tool to seek help.
